Also known as a drain auger, a drain snake is a coiled device around ¼-inch thick. To use a drain snake, put the end into the entrance of the drain. Turn the handle to force the snake deeper, using extra pressure to force it through the bend in the pipe. Keep turning until the snake hits the clog, then either pull the snake and remove the obstruction or force it through. Once the snake is out of the drain, run the water on full blast for a few minutes to ensure the obstruction is completely removed.
“Intelligent Service replaced our two sump pumps, added digital float switches, and installed a digital wall unit to track the water levels and pump options. They also checked our existing battery backup for battery outputs. They improved the piping and fixed the check valves. They cleaned the sump pit and the work area. They did a terrific job. Will definitely use them again and will recommend them as well. Pleasure to work with, very responsive, knowledgeable staff, and did a good job explaining the work order prior to writing up the estimate.”

Plumbing Service

×