Also known as a drain auger, a drain snake is a coiled device around ¼-inch thick. To use a drain snake, put the end into the entrance of the drain. Turn the handle to force the snake deeper, using extra pressure to force it through the bend in the pipe. Keep turning until the snake hits the clog, then either pull the snake and remove the obstruction or force it through. Once the snake is out of the drain, run the water on full blast for a few minutes to ensure the obstruction is completely removed.
The movement of liquids and gases through pipes is critical to modern life. In homes, water is needed for both drinking and sanitation. In factories, chemicals are moved to aid in product manufacturing. In power plants, steam is moved to drive turbines that generate electricity. Plumbers, pipefitters, and steamfitters install and repair these pipe systems.
While it’s their job to make sure your pipes work like a well-oiled machine, it’s not their job to rebuild the wall they had to demolish to make that happen. So, while you’re going to get that water problem fixed, you’ll want to discuss in detail what kind of “mess” they might leave behind prior to the start of the project so you can plan accordingly. Remember, there are some jobs you can do yourself. Here’s how to solder copper pipe joints!

Plumbing Service Company


“Intelligent Service replaced our two sump pumps, added digital float switches, and installed a digital wall unit to track the water levels and pump options. They also checked our existing battery backup for battery outputs. They improved the piping and fixed the check valves. They cleaned the sump pit and the work area. They did a terrific job. Will definitely use them again and will recommend them as well. Pleasure to work with, very responsive, knowledgeable staff, and did a good job explaining the work order prior to writing up the estimate.”

Plumbing Service

×